Decal & Banner Installation Instructions

  1. Thoroughly clean the application area with rubbing alcohol or soap and water and allow to thoroughly dry. DO NOT USE WINDEX!

  2. Prepare the decal or windshield banner for application by firmly rubbing a squeegee or credit card across the transfer tape. This process removes any air bubbles that may have formed and will provide better adhesion to the transfer tape.

  3. Locate and mark the center of the decal or windshield banner. The center can be easily found by gently folding the banner lengthwise in half. The resulting crease is the center.

  4. Place the decal or banner in the desired location with a piece of masking tape on the top of the decal or banner to secure in place. (For windshield banners, once secured in place, it is often easier to cut the banner into 3 parts between letters. Section 1: CULLMAN
    Section 2: CO + COUNTY OUTLINE
    Section 3: WRANGLERS

  5. Once the desired location is complete, slowly and carefully, begin to peel the white paper backing from the decal or banner up and away from the vinyl lettering. Be careful not to pull off the masking tape securing your decal or banner in place.

  6. Slowly lower the decal or banner and rub the transfer tape securely in place with a squeegee or credit card. Start at the top middle and then the outer edges. Firmly rub the decal or banner in place to make sure there is no air trapped under the sticker. Repeat for each part.

  7. For best results wait 30 minutes then slowly peel the clear cover off at an angle. Be careful not to pull the sticker off the surface. If the sticker pulls away from the surface repeat step 4.


For further assistance in installing decals and/or banners, please contact our supplier Inked Auto Vinyl.